Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair Before & After in Torrance, CA
You can read about sagging hinges and dead operator boards all day, but nothing shows the work like a side-by-side. Below are recent gate repair jobs in Torrance that started with a failure and ended with a documented record. Every project below includes the photo log we left with the homeowner.
Recent Transformations
Swing Gate Motor Replacement on a LiftMaster LA400
The problem: the gate would open six inches and stop. We found the limit switch set 12 degrees past travel, and the board had been fighting it long enough to burn the capacitor. What we did: replaced the motor, reset the limit switch, and photographed the new position. The result: a gate that opens and closes on its mark, with a written record of the part number left with the customer.
Welding Repair on a Twisted Steel Driveway Gate
The problem: a car backed into the gate and twisted the top rail, pulling the hinge welds out of square. What we did: cut out the bent section, re-welded the rail, and reinforced both hinge plates. The result: the gate hangs true again, and the welds were photographed before paint so the customer could see exactly what was done under the finish.
Ghost Controls Opener Retrofit on a Sliding Gate
The problem: an old chain-drive opener had stripped its sprocket, and the chain had been dragging on the track for weeks. What we did: removed the old drive, installed a Ghost Controls kit, and replaced the worn rollers at the same time. The result: the gate slides quietly and the customer kept the old sprocket as a paperweight, because it was that far gone.
Photo-Eye Realignment on a Viking Operator
The problem: the gate would reverse every third cycle for no apparent reason. We found the photo-eye, the infrared beam that stops the gate if something crosses the path, misaligned by roughly two inches. What we did: realigned both eyes, cleaned the lenses, and verified the beam with a test block. The result: no more phantom reversals, and the customer got a photo of the beam alignment in the job record.
DoorKing Circuit Board Swap on an Access Control Gate
The problem: the keypad worked, the motor hummed, and nothing moved. The board had stopped sending the open command to the actuator. What we did: swapped in a new DoorKing board, transplanted the existing programming, and tested the loop detector at the same time. The result: the gate cycles on command, with the old board photographed and the wiring documented before we closed the box.
Hinge Replacement on a Sagging Wood Gate
The problem: the gate had sagged far enough to drag on the concrete, and the hinges looked like they had been lubricated during the Obama administration. What we did: replaced both hinges with heavier-gauge steel, squared the frame, and added a diagonal brace to keep it from sagging again. The result: the gate clears the ground by a full inch and swings with one hand.
Want Results Like These?
Every project on this page is the kind of work we do in Torrance every week. We quote a written price before any work starts, and we photograph everything before we leave. Call (424) 373-8425 and send us photos of what your gate is doing right now. We’ll tell you what we think it is.
Written by Adrian Vance, Owner at Vance Gate Repair Torrance, serving Torrance since 2014.